|
Isolation Amplifier DN 2000
- Calibrated signal setting
Input and output range can be set by using DIP switch – without any further adjustment - Universal Power Supply for 20 ... 253 V AC/DC
Applicable world-wide for all common supply voltages - 3-port isolation
Protection against erroneous measurements due to parasitic voltages or ground loops - Ultra-small-sized housing
12.5 mm housing with plug-in screw terminal blocks - High accuracy
No falsification of measured signal - Protective Separation
Protects service personnel and downstream devices against impermissibly high voltage - Maximum reliability
No maintenance costs - 5 Years Warranty
Defects occurring within 5 years from delivery date shall be remedied free of charge at our plant (carriage and insurance paid by sender)
|
|
DN2000
고성능 슬림형 표준 신호변환기 Isolation Amplifier DN 2000
절연증폭기 DN 2000은 0 ~ 20mA, 4 ~ 20mA 및 0 ~ 10V 표준 신호를 절연하고 변환하는 데 사용됩니다.
The Isolation Amplifier DN 2000 is used for isolation and conversion of 0 to 20 mA, 4 to 20 mA and 0 to 10 V standard signals.
입력 | 0
~ 20mA 4
~ 20mA 0
~ 10V |
출력 | 0
~ 20mA 4
~ 20mA 0
~ 10V |
전원 | 범용전원
20 ~ 253V AC/DC (DC24V
/ AC220V 가능) |
특징 |
높은 내전압
4kV, DIP 스위치로
입력/출력 설정 및 변경
|
- 보정된 신호 설정
DIP 스위치를 사용하여 입력 및 출력 범위를 설정할 수 있습니다.
- 범용 전원 공급 장치, 20 ~ 253V AC/DC
모든 공통 전원 전압에 대해 전세계적으로 적용 가능
- 3 -port 절연
부유전압(Stray
Voltage) 또는 접지루프(Ground
Loop)로 인한 잘못된 측정으로부터 보호
- 초소형 하우징
플러그인 나사 단자 블록이
있는 12.5mm 하우징
- 높은 정확성
측정된 신호의 위조 없음
- EN
61140 (KS
C IEC 61140) 규격에 따른 감전보호
허용되지 않는 고전압으로부터 서비스 요원 및 후속 장치를 보호합니다.
- 최대 신뢰성
유지 보수 비용 없음
- 5년 보증
배송일로부터 5년 이내에 발생하는 결함은 무료로 수리
또는 교환해 드립니다.
|
신호
절연증폭기(Isolation Amplifier) DN2000은 0 ~ 20mA, 4
~ 20mA 및 0 ~ 10V 표준신호를 분리하고 변환하는데 사용됩니다.
보정된
입력 및 출력 범위 덕택에 새로운 범용 전원공급 장치와
초소형 하우징의 절연증폭기는 유연한 사용에 적합합니다.
높은 신뢰성과 방호분리(Protective Separation)는 안전한
시스템 작동을 보장하는 추가 기능입니다.
원하는
입력 및 출력 범위는 DIP 스위치를 사용하여 쉽게 설정할
수 있으며 보정된 범위선택으로 인해 더 이상 조정할 필요가
없습니다. 또한 DIP 스위치를 사용하여 차단 주파수 (Cut-off
Frequency)를 측정 작업에 적용할 수 있습니다. 또는 모든
신호 조합을 고정범위 변환기로 사용할 수도 있습니다.
12.5mm
너비의 슬림형 하우징은 제어반 공간을 절약하고 실용적인
플러그인 나사 단자 블록(Plug-in Screw Terminal Block)은 조립을 용이하게 합니다. 범위설정을
위하여 DIN 레일에 있는 것을
포함하여 모든 제어장치에 쉽게 접근할 수 있도록 간단한 하우징 래치가 제공됩니다.
20
~ 253V AC/DC의 새로운 범용 전원팩(Universal Power Pack)은
모든 주전원 공급 장치가 있는 전세계 어느 곳에서나 DN2000을
사용할 수 있음을 의미합니다. 이 장치의 고효율성은 변환기의
자체발열을 줄이는데 크게 기여합니다. 이는 매우 높은
신뢰성과 장기적인 안정성에 반영됩니다. 전원공급을 모니터링하기
위해 장치 전면에 녹색 LED가 제공됩니다.
The Isolation Amplifier DN 2000 is used for isolation and conversion of 0 to 20 mA, 4 to 20 mA and 0 to 10 V standard signals.
Due to the calibrated selection of the input and output ranges, the new universal power supply and the ultrasmall housing the Isolation Amplifier is suitable for flexible use. The high reliability and the protective separation are further features, which ensure a safe system operation. The desired input and output range can be easily set by using DIP switch and due to the calibrated range selection no further adjustment is necessary. Also the cutoff frequency can be adapted to the measurement task by using the DIP Switch. Alternatively, all signal combinations are also available in the form of fixed range units. The slim housing with 12.5 mm width saves space in the switch cabinet and facilitates by the practical plug-in screw terminal blocks the assembly. A simple housing latch has been provided for range setting purposes to make all the operating elements, including those on the DIN-rail, easily accessible. The new universal power pack for 20 ... 253 V AC/DC means the DN 2000 can be used anywhere in the world, with all mains power supplies. The unit’s high efficiency contributes significantly to reducing the unit’s own heat generation. This is reflected in extremely high reliability and long-term stability. A green LED on the front of the unit has been provided to monitor the power supply.
Technical Data
Input
Input signal | 0...20 mA, 4...20 mA, 0...10 V, calibrated switchable | Input resistance | Current input Voltage input | 22 Ohm 1 MOhm | Input capacitance | Approx. 1 nF | Overload | Current input Voltage input | ≤ 200 mA Voltage limitation via 30 V Z-Diode, max. continuous current 30 mA |
Output
Output signal | 0...20 mA, 4...20 mA, 0...10 V, calibrated switchable | Load | Current output Voltage output | ≤ 12 V (600 Ohm at 20 mA) ≤ 10 mA (1 kOhm at 10 V) | Linear transmission range | –2 ... +110 % | Residual ripple | < 10 mVrms |
General Data
Transmission error | < 0.1 % full scale | Temperature coefficient 1) | < 50 ppm/K | Cut-off frequency -3 dB | 1 kHz, DN 2000 switchable to < 30 Hz | Response time T99 | 0.7 ms 20 ms | Test voltage | 4 kV, 50 Hz, 1 min., input against output against power supply | Working voltage 2) (Basic Insulation) | 600 V AC/DC for overvoltage category II and pollution degree 2 acc. to EN 61010-1 | Protection against electrical shock 2) | Protective separation according to EN 61140 by reinforced insulation in accordance with EN 61010-1 up to 300 V AC/DC for overvoltage category II and pollution degree 2 between all circuits. | Ambient temperature | Operation Transport and storage | –20 °C to +70 °C –35 °C to +85 °C | Power supply | 20 ... 253 V AC/DC, | AC 48 ... 62 Hz, approx. 2 VA DC approx. 1.0 W | EMC 3) | EN 61326 -1 | Construction | 12.5 mm (0.49") housing, protection classt: IP 20 mounting on 35 mm DIN rail acc. to EN 60715 | Weight | Approx. 100 g |
Block
Diagram
|
Dimensions
|

|

|
Terminal assignments
/ Wire cross-section max. 2,5 mm², Multi-wire connection max. 1 mm² (two wires with same cross-section)
1 | Input current + |
5 | Output + |
2 | Input current - |
6 | Output - |
3 | Input voltage + |
7 | Power supply ~ |
4 | Input voltage - |
8 | Power supply ~ |
제품
주문 코드 Order Codes
품목 |
입력 |
출력 |
주문번호 |
DIP 스위치를 이용하여
보정된 입출력
범위 선택
Isolation Amplifier, calibrated range selection
|
0
to 20mA, 4 to 20mA, 0 to 10V 으로
입출력을 선택하여 전환 가능 |
DN 2000 AG |
Isolation Amplifier, fixed setting
| 0 to 20 mA | 0 to 20 mA |
DN 2012 AG | 4 to 20 mA | 0 to 20 mA |
DN 2032 AG | 0 to 10 V | 0 to 20 mA |
DN 2052 AG | 0 to 20 mA | 4 to 20 mA |
DN 2014 AG | 4 to 20 mA | 4 to 20 mA |
DN 2012 AG | 0 to 10 V | 4 to 20 mA |
DN 2054 AG | 0 to 20 mA | 0 to 10 V |
DN 2016 AG | 4 to 20 mA | 0 to 10 V |
DN 2036 AG | 0 to 10 V | 0 to 10 V |
DN 2056 AG |
여기에
표기된 사양들은 예고 없이 변경될 수 있습니다! (Specifications
listed here are subject to change without notice!)

|